EXPLORE THE NEW TRENDS AND ADVANCED TECHNOLOGIES IN THE HEAT TREATMENT EQUIPMENT INDUSTRY
Ask for a free consultation Ask for technical support
Электронная почта
Тел
WhatsApp/WeChat
Свяжитесь с нами
Все продукты настраиваемы, оставьте сообщение немедленно, мы ответим как можно скорее.
Nuotai Technology has sorted out some of the problems and solutions encountered in the use of vacuum experimental furnaces for everyone. Let's take a look at it together:
1. Temperature failure of high temperature vacuum furnace:
Causes: (1) The thermocouple wire is disconnected or contaminated (2) The temperature control instrument is faulty (3) The thermocouple compensation wire is connected reversely or short-circuited
Remedy: (1) Replace the thermocouple (2) Repair according to the instrument manual (3) Reconnect or eliminate
2. The maximum temperature of the vacuum furnace cannot reach the rated value:
Causes: (1) Necrosis of the heat shield (2) Aging of the heating element
Remedy: (1) Repair or replace the heat shield (2) Replace the electric heating element
3. The oil temperature is too high:
Causes: (1) Sundries are sucked into the pump (2) The temperature of the sucked gas is too high (3) The amount of cooling water is insufficient
Remedy: (1) Remove debris (2) Install a cooling device on the air inlet pipe (3) Enhance the cooling water flow
4. The surface of the gas quenched parts is not bright
Causes: (1) The furnace vacuum is low (2) The purity of the shielding gas is not enough (3) The charging pipeline is not pre-exhausted
Remedy: (1) Increase the vacuum degree of the furnace (2) Increase the purity of the shielding gas (3) Before opening the furnace, the charging pipeline should be pre-exhausted.
№ 104, здание 31, промышленный парк по производству оборудования Синьян,
город Чжэнчжоу, провинция Хэнань,
Китай Zhengzhou Protech Technology Co., Ltd.
郑州诺泰科技有限公司
Оставить сообщение
English
简体中文
Français
日本語
بالعربية
한국어
Português
Русский
Español
